Heavy Duty differential covers and transmission pans are essential in allowing for the proper amount of lubricant and cooling capacity for often used and strained vehicles. Mag-Hytec produces many fine quality products that add luster without sacrafcing functionality. Manufactured with A3560-T6 aluminum, a dark powder coated finish and machined cooling fins; Magnetic drain plugs help confine worn gear material, this action helps maintain the fluid integrity. All units are fitted with an ARP 568 The hardware is composed of 303 stainless steel and for many situations no gasket or sealent is required. Mag-Hytec products and parts are all protected by a lifetime limited warranty. When you need a quality product to pull a heavy load, be sure to use a Mag-Hytec product.
Avoid costly reapirs - Extend the life of your Vehicle - Expand oil Capacity - Runs Cooler, Lasts Longer
|
- Average of double the fluid capacity
- Ease of Service
- The dipstick is knurled for quick removal, the flat is marked low/high to check lube level and a magnet, which acts as an open filter is in the lower end. The MS 7/8 - 14 THD port is large enough to use for filling.
- The magnet-filled drain plug is the same MS port as the dipstick. Both the dipstick and drain are O-ring sealed.
- The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug.
- The calibration plug is centered on the serial number plate and approximates the stock cover fill plug for factory fluid level.
- The O-ring is snapped into the inverted "V" groove for a positive seal without gasket or silicone.
- Plugs, cap screws and washers are stainless steel in most applications.
|
Over time the metal inside compoents will start to breakdown, this breakdown creates small particles that often end up being mixed into the lubrication fluid and oil. The use of a magnet helps filter out the oil of these metallic impurities and thus keeps the lubricating oil cleaner and extends the life of the component being lubricated. It is recommonded that you check and remove any debris from the magnent, doing so will prevent the magnent from becoming inefficent.
MAG-HYTEC'S heavy duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and service vehicles. MAG-HYTEC covers and pans set your vehicle apart in both aesthetics and function - cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear material promoting fluid integrity. Each unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless steel, in most applications no gasket or sealant is required, and all MAG-HYTEC parts are covered by a lifetime limited warranty. Depend on MAG-HYTEC when you're pulling a heavy load.
Why MAG-HYTEC
- Heavy Duty Differential Covers and Transmission Pans
- Expand oil Capacity
- Runs Cooler
- Avoid costly repairs
- Lasts Longer
- Extends the life of your Vehicle
MAG-HYTEC'S heavy duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and service vehicles.
MAG-HYTEC covers and pans set your vehicle apart in both aesthetics and function - cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear material promoting fluid integrity. Each unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless steel, in most applications no gasket or sealant is required.
Depend on MAG-HYTEC when you're pulling a heavy load.
All MAG-HYTEC products are covered by a lifetime limited warranty to the original owner against defects in parts and workmanship.
O-rings are covered for five years.